Installing Cutterbar Deflectors - MacDon R113 Operator's Manual

1. Raise mower conditioner fully, shut down tractor, and
remove key from ignition.
2. Close lift cylinder lock-out valves.
3. Clean debris from deflectors and deflector area.
IMPORTANT:
Do NOT remove plug (B).
4. Remove three bolts (C) securing deflector (A) to
cutterbar using an 8 mm hex key and a 16 mm socket
and remove deflector.
5. Repeat for other deflector.
6. Store deflectors and hardware in a safe place.
Installing Cutterbar Deflectors
DANGER
To avoid bodily injury or death from unexpected start-up or fall of a raised machine, stop engine, remove
key, and engage header lift cylinder lock-out valves before going under machine for any reason.
1. Raise mower conditioner fully, shut down tractor, and
remove key from ignition.
2. Close lift cylinder lock-out valves.
3. Clean debris from ledge and the six mounting holes
along aft edge of cutterbar.
4. Position left deflector (A) (with cut-out for cutterbar
drain plug (B)) on top of ledge along the aft end of the
cutterbar, and align existing fasteners and cutterbar
plug with slots in deflector (A).
5. Install three button hex head socket M10 bolts (C) with
lock nuts in the holes with the heads facing down.
147910
OPERATION
Figure 3.120: Left Cutterbar Deflector Viewed
from Underside of Cutterbar
Figure 3.121: Left Cutterbar Deflector Viewed
from Underside of Cutterbar
98
Revision A