Connecting Transport Lighting Module - Without Dealer-Installed Transport - MacDon R113 Assembly Instruction Manual
Rotary disc pull-type
Hide thumbs
Also See for R113:
- Operator's manual (294 pages) ,
- Unloading and assembly instructions (166 pages) ,
- Assembly instruction manual (136 pages)
Table of Contents
Advertisement
ASSEMBLING THE ROTARY DISC PULL-TYPE – WITH OR WITHOUT THE DEALER-INSTALLED TRANSPORT
3.7 Connecting Transport Lighting Module – Without Dealer-Installed
Transport
The hitch assembly lighting harness must be connected to the lighting module on the header.
NOTE:
Follow these instructions if NOT installing the dealer-installed transport kit.
1. Remove plug (A) from the upper input receptacle on
transport lighting module.
2. Locate plug P102 on trailer harness (A) at the header end of
the hitch. Route plug P102 towards the transport lighting
module.
3. Secure the trailer harness with existing P-clip (D).
4. Connect plug P102 (B) to the upper input receptacle on
transport lighting module (C).
215585
Figure 3.56: Lighting Module Plug
Figure 3.57: Trailer Harness
32
Revision A
Advertisement
Table of Contents
