Scanner Back - Kodak Ngenuity 9090DB Operator's Manual

Ref# Item Name
1 Back Imprinter
Door
2 Straight Pass-
Through Door
3 SCSI
Connector
4 USB
Connector
5 Power Switch
S008769 Rev A
The back imprinter is installed and accessed through this door. It requires
an additional 3.5" (9 cm) of clearance to open fully (see
page 4). For more information about the imprinter, see
page 53.
Enables the use of the Straight Pass-Through scanning feature. When the
straight pass-through door is open, documents are fed straight through the
scanner and exit out the back of the scanner. This is useful for scanning
thick or stiff documents. The straight pass-through door requires an
additional 3.5" (9 cm) of clearance to open fully (see
page 4).
N
OTE
While scanning documents in rotary mode (straight pass-
through feature NOT being used), do NOT open the straight
pass-through door. Doing so can cause a physical paper jam or
cause the scanner's firmware to issue a paper jam error.
Connector for attaching optional SCSI cable (cable and SCSI card not
provided). For more information about the optional SCSI connection, see
"4.2 SCSI Connection" on page
Connector for attaching supplied USB cable which also attaches to the
host PC and is used to establish communication between the two.
Toggle switch used to apply or remove power to the scanner. 'I' = ON; and
'O' = OFF.

1.4.2 Scanner Back

Description
Side View-2 on
53.
Side View-2 on
"4.1 Imprinter" on
11