Replacing Tires - Kodak Ngenuity 9090DB Operator's Manual

6. Using the Cleaning Wipes, scrub the drive roller tires in a side to
side (<------->) motion taking care to rotate the roller, cleaning
the entire surface of the tires
7. Re-install the clean, drive roller back into the scanner
- Hold the back drive roller between your thumb and index
finger of your left hand with the markers on the roller tires
visible on the left side (note - if the roller is installed with the
markers on the wrong side, the roller/skimmer will not
function properly)
- Angle the right side of the drive roller onto the right drive roller shaft. Push the roller onto
the shaft and push the roller and shaft far enough to the right so that the left side of the
roller can be positioned onto the left drive roller shaft
- Once the left side of the drive roller is properly aligned onto the left drive roller shaft, allow
the spring action of the right drive roller shaft to push the drive roller into place
8. After cleaning both skimmer rollers, clean the separator roller (see
Roller" on page 66)
9. Close the scanner's transport cover
10. Once both the skimmer rollers and separator
rollers are cleaned, reset the maintenance
reminder for cleaning the Feed Rollers located in
the Maintenance Monitor section of the NOU's
Home Screen
- With the NOU active and communicating with
the scanner (see
Utility" on page
hyperlink associated with "Clean Feed
Rollers" in the Maintenance monitor of the
Home screen
- A confirmation dialog window will display.
Confirm the Feed Rollers have been cleaned
by clicking the YES button. This will reset the
reminder to begin monitoring for the next
required maintenance session
With proper cleaning, BBH estimates the tire life of each skimmer roller (pick and drive) to equate
to approximately 600,000 pages fed. Different document types, the condition of the documents
being scanned, and the volume of scanning may alter that number slightly.
If replacing tires, all four tires should be replaced at the same time. When replacing tires, also
replace the separator roller (see
S008769 Rev A
"2.2 Ngenuity Operator
29), click on the Clean
"Replacing the Separator Roller" on page
Markers on
Left Side
"Cleaning the Separator
R T
EPLACING IRES
67).
63