Kodak Ngenuity 9090DB Operator's Manual page 93

3. Clicking on either one of the Calibrate links (front or back)
will display the Select Cameras screen. From this screen
the user should select the 'Both' option for calibrating both
cameras and then click the START button
4. Lift the skimmer. The scanner will automatically go into manual mode (see
page 21). The feeder table will rise and the transport will begin to run
5. When the feeder table rises to the full up position, feed the stack of 2 calibration sheets into
the transport in landscape orientation
6. The calibration process begins and the NOU will
display the following dialog
A counter and a progress bar will mark the
progress of the calibration steps.
C
AUTION
Do NOT shut down the scanner while calibration is in progress.
Do NOT open the scanner's transport cover while calibration is in progress.
Do NOT attempt to shut down the host PC while calibration is in progress.
Do NOT manipulate any software applications on the host PC or other host PC controls while
calibration is in progress.
Performing any of the above mentioned acts during the calibration process could result in
calibration failure.
7. When the calibration function has completed all
steps successfully, a confirmation screen will dis-
play. Click the CLOSE button. The calibration
sheets will be automatically ejected from the
scanner
N
OTE
If the confirmation screen states that the calibration was unsuccessful, power OFF the
scanner, shut down the host PC, clean the scanner's optics and begin the procedure again.
If the calibration is unsuccessful a second time, contact the BBH Help Desk at 1-800-SCAN-
495 or your local BBH Authorized Service Provider (ASP). A list of ASPs can be found on the
BBH web site at www.bbhscanners.com.
S008769 Rev A
The prompt to lift the skimmer and manually feed the
calibration sheets into the scanner will display.
"Manual Mode" on
81