Back Door Led; Maintenance Led - Kodak Ngenuity 9090DB Operator's Manual

Power State or Transition
OFF
READY
SLEEP > READY
READY/ACTIVE
READY > SLEEP
SLEEP
The BACK DOOR LED indicator displays the status of the scanner's straight pass-
through door located in the back of the scanner (see
page 11). When lit, the BACK DOOR LED indicator is green in color.
The table below identifies the various actions of the BACK DOOR LED depending upon the state
of the scanner's straight pass-through door:
Back Door State
Straight pass-through door is closed; normal
full transport path to exit tray is in use
Straight pass-through door is open; docu-
ments being scanned will be transported to
rear exit rather than normal
When lit, the MAINTENANCE LED indicates that maintenance or service
conditions exist in the scanner (see
more information). When lit, the MAINTENANCE LED is yellow in color.
S008769 Rev A
Pushbutton Function
N/A - control panel and scanner electronics not powered
Pushbuttons are ignored during this initialization transition
Pushbuttons are ignored during this initialization transition
All pushbuttons perform their normal operational functions. Press
and hold the STOP pushbutton for 5 seconds to put the scanner
immediately to sleep
Momentary press of any pushbutton re-triggers the sleep timer and
prevents transition to SLEEP mode; scanner resumes a READY
mode
Momentary press of any pushbutton wakes up the scanner (starts
the SLEEP > READY transition)
"1.4.2 Scanner Back" on
exit tray
"2.2.2.3 Maintenance Monitor" on page 35

2.1.1.2 Back Door LED

Back Door LED
OFF (not lit)
STEADY ON

2.1.1.3 Maintenance LED

for
19