Kodak Ngenuity 9090DB Operator's Manual page 19

Ref# Item Name
4 Extender,
Feeder Table
5 Document
Feed Guides
(Left & Right)
6 Skimmer
Module
7 Separator
Roller Door
8 Transport
Cover Release
Levers
9 Transport
Cover
10 Document
Output Guides
(Left & Right)
11 Exit Deflector
S008769 Rev A
The extender for the feeder table acts as a support mechanism for longer
documents that extend out and beyond its standard length. The extra
support allows for better feeding of document(s) into the scanner's
transport. The extender can be pulled out to add an approximate 7.0" (18
cm) of length to the feeder table.
The document feed guides and are used to guide document(s) into the
scanner's transport with little or no skew. They can be width adjusted
independently of one another, which allows the Operator to left, right, or
center align documents for feeding into the scanner's transport.
The skimmer (assembly) contains two rollers that assist in grabbing and
feeding documents from the feeder table into the scanner's transport. The
skimmer assembly can be placed in an up position (manual feeding - see
2.1.1.5 Feed Modes, 'Manual Mode" on page
(automatic document feeding - see 2.1.1.5 Feed Modes,
page 21). The skimmer rollers can get dirty and wear over time. They
require periodic cleaning and eventual replacement to maintain optimal
performance (refer to the section
for more information).
Behind the separator roller door is the separator roller. The separator roller
assists in separating documents as they feed into the scanner's transport
so as to avoid the occurrence of multifeeds. The separator roller can get
dirty and wear over time. It requires periodic cleaning and eventual
replacement to maintain optimal performance (refer to the section
'Maintenance" on page 57
There are two transport cover release levers, one located on the left side of
the scanner and one on the right. The Operator is required to pull one or
both lever mechanisms towards them while standing in the front of the
scanner to release and open the scanner's transport cover for opening in
an upward position.
The transport cover is a hinged cover that can be opened to access the
scanner's transport. It opens in an upward position and will stay open in a
full up position with the support of two gas springs that are located inside
the scanner - one on either side (see
image of the transport cover in a full up position).
The document output guides are used to guide the scanned document(s)
out of the transport into a neat stack on the exit tray
adjusted independently of one another, which allows the Operator to left,
right, or center align documents exiting the scanner's transport, depending
on how the documents are fed into the scanner (see
Hinged deflector that assists in the placement of documents in the Exit
Tray
Description
21) or a down position
'Maintenance" on page 57
in this manual for more information).
Side View-2 on page 4
'ADF Mode" on
in this manual
to view an
a
. They can be width
#5 above)
7