Cleaning The Skimmer Rollers - Kodak Ngenuity 9090DB Operator's Manual

.
Transport Cover Open
(view from front)
Pick Roller
Drive Roller
Over time the tires on the skimmer rollers (pick and drive rollers) will become dirty and may begin
to slip on paper or cause multifeeds. To prevent feeding problems and avoid rubber tire
replacements, BBH recommends cleaning the skimmer rollers (tires) every 10,000 pages fed or
as needed. Different document types, the condition of the documents being scanned, and the
volume of scanning may require more frequent cleanings.
Always remove the rollers from the scanner for cleaning to ensure best results.
Item(s) Needed
• Cleaning Wipes
To clean the skimmer rollers, perform the following:
1. Power OFF the scanner (see 1.4.2 Scanner Back,
2. Open the scanner's transport cover (see 1.4.1 Scanner Front,
and "Transport Cover Release Levers" on page 7)
3. Remove the pick roller
- Hold the pick roller with your left hand
- With your right thumb, flip the blue pick roller release lever up towards the top of the scan-
ner so that the lever clears the pick roller and the roller can be moved all the way to the far
right (as viewed from the front of the scanner).
- Once in the far right position, the left side of the pick roller should clear the left gear shaft
and can be lifted out and away from the scanner (note - the pick roller's right roller shaft
swings out and away from the scanner for easier removal and replacement of the roller)
S008769 Rev A
Skimmer
Assembly
Tire Tire
Tire Tire
C
LEANING THE
"Power Switch" on page
Pick Roller
Release Lever (blue)
Right Drive Roller
Shaft (spring loaded)
S R
KIMMER OLLERS
11)
"Transport Cover" on page 7
61