Kodak Ngenuity 9090DB Operator's Manual page 74

4. Using the Cleaning Wipe, scrub the roller tires in a side to side
(<------->) motion, taking care to rotate the roller, cleaning the
entire surface. Re-install the clean pick roller back into the scan-
ner
- With the pick roller positioned so that the markers located on
the end of the roller tires are visible on the left side, slide the
roller onto the right pick roller shaft (note - if the pick roller is
installed with the markers (red dots) on the wrong side, the
roller/skimmer will not function properly)
- Angle the left side down or back towards the skimmer housing and then all the way left,
onto the left pick roller shaft (note - the right side of the roller should now be clear of the
pick roller release lever)
- Bring the pick roller release lever down over the roller shaft and lock (snap) into place,
securing the pick roller
5. Remove the drive roller
- Position the index finger of your left hand on the left side of the drive roller. Push the roller
as far right as possible and hold it there
- The right drive roller shaft which works on a spring, will shift along with the roller and pro-
trude out of the right side of the scanner's upper tray. Position the index finger of your
right hand on the area of the drive roller shaft that is protruding out from the right side of
the scanner's upper tray and hold the shaft there, in place
Left Drive
Roller Shaft
- While holding the right drive roller shaft in place, grasp the entire drive roller with your left
hand, ease it off of the remaining part of the right drive roller shaft, and remove it from the
scanner
- Slowly remove your right index finger from the right drive roller shaft, easing it back into its
fully engaged position
62
Drive Roller in
far right position
(must be held
there...)
Markers on
Left Side
Right Drive
Roller Shaft
(extended)
S008769 Rev A