Feed Modes; Adf Mode; Manual Mode - Kodak Ngenuity 9090DB Operator's Manual

The Ngenuity scanner has four available feed modes for feeding documents into the scanner's
transport: ADF mode; Manual mode; Assisted Manual mode (type of Manual mode); and Test
Feed mode.
With the exception of the Test Feed mode, the type of feed mode the scanner uses is set by the
Operator through the scanner properties window that resides within the software application being
used for scanning.
ADF mode is the default feed mode for the scanner. It is used for feeding batches of documents
that are similar in size and weight. After being placed on the feeder table, a batch of documents is
fed automatically into the scanner's transport one at a time.
Manual mode is used to feed documents that can't tolerate the separation operation of ADF Mode
(e.g. multiple forms). In Manual mode the Operator is required to manually feed documents into
the scanner's transport one at a time. When scanning in Manual mode, the MANUAL FEED LED
on the scanner's control panel will be lit (see
To scan documents using Manual mode, perform the following:
N
OTE
For demonstration purposes, VCDemo (scanning application that automatically loads with the
Ngenuity VRS Professional software) is used in the following procedure.
1. Power ON the scanner (see 1.4.2 Scanner Back,
scanner's initialization sequence to complete
2. Place the skimmer in the up position (for skimmer identification, go to
on page 6)
3. Boot up the host PC
4. Launch the scanning application (in this example, VCDemo)
5. Select the scanner
VRS ImageControls®-based Applications
- Bowe Bell+Howell 9000 with VRS
- Bowe Bell+Howell 9000 with VRS with AIPE
S008769 Rev A
"2.1.1.4 Manual Feed LED" on page
"Power Switch" on page

2.1.1.5 Feed Modes

ADF M
M M
ANUAL
20).
11) and wait to the
"1.4.1 Scanner Front"
ODE
ODE
21