Lamps (Leds); Feeder Cork Pad Replacement - Kodak Ngenuity 9090DB Operator's Manual

C
AUTION
The LEDs on Ngenuity scanners should NOT be cleaned or wiped with any type of wipes and/
or solvent
N
OTE
The LED illumination system on Ngenuity scanners should last the life of the scanner with
normal use. If something happens that requires the replacement of the LEDs, contact the BBH
Help Desk at 1-800-SCAN-495 or your local BBH Authorized Service Provider (ASP). A list of
BBH ASPs can be found on the BBH web site at www.bbhscanners.com.
The cork pad located on the feeder table should not need cleaning; however, it may wear over
time and require replacement for optimal feeding performance (for more information about the
cork pad, see 1.4.1 Scanner Front -
Separator
Roller Door
Item(s) Needed
• New cork pad
To replace the cork pad, perform the following:
1. Power OFF the scanner (see 1.4.2 Scanner Back,
S008769 Rev A

5.3.7 Feeder Cork Pad Replacement

"Cork Pad" on page
Cork Pad
Feeder Table

5.3.6 Lamps (LEDs)

6).
Feeder Sensor
"Power Switch" on page 11)
83