Manual Feed Led - Kodak Ngenuity 9090DB Operator's Manual

The table below identifies the various actions of the MAINTENANCE LED depending upon the
state of the scanner:
Scanner State
System OK; no maintenance currently
required
Maintenance needed (see
Operator Utility" on page 29
information)
Scanner Busy/Offline; occurs when scanner is
in off-line mode and not capable of scanning
(occurs when scanner is in a special mode
such as ADF Test, during camera calibration,
while downloading firmware, performing an
imprinter cleaning)
Self-test failure; needs service (coincides with
the reminders displayed in the Maintenance
Monitor of the Ngenuity Operator Utility (NOU)
- see "2.2.2.3 Maintenance Monitor" on
page 35)
N
OTE
In the event a self-test failure occurs, contact your local BBH Authorized Service Provider
(ASP). A list of BBH ASPs can be found on our web site at www.bbhscanners.com.
The MANUAL FEED LED indicates whether or not the feed mode has been
changed from the normal/default ADF (Automatic Document Feed) mode to the
Manual mode. When lit, the MANUAL FEED LED is green in color.
The table below identifies the various actions of the MANUAL FEED LED depending upon the
feed mode setting on the scanner (see
Feed Mode Setting
ADF feed mode
Manual feed mode
20
Maintenance LED
OFF (not lit)
SLOW BLINKING
"2.2 Ngenuity
for more
FAST BLINKING
STEADY ON
"2.1.1.5 Feed Modes" on page 21

Manual Feed LED

OFF (not lit)
STEADY ON
2.1.1.4 Manual Feed LED
for more information):
S008769 Rev A