Feed Rollers; Skimmer Rollers - Kodak Ngenuity 9090DB Operator's Manual

Should you have any questions about the following procedures, please contact the BBH Help
Desk at 1-800-SCAN-495. Questions about cleaning supplies and kits should be directed
Scanner Sales at 1-800-SCAN-494.
W
ARNING
Before performing any maintenance procedures, power OFF the scanner.
W
ARNING
Before performing any maintenance procedures on the scanner, remove all jewelry or any
items from hands or wrists that could become caught on internal scanner components.
The Skimmer (Pick and Drive) and Separator Rollers make up what is referred to as the Feed
Rollers.
All Feed Rollers should be cleaned and/or replaced at the same time to ensure optimal scanner
function. Maintenance reminder intervals (both cleaning and replacing) are based on all Feed
Rollers having the same life cycle (see
The skimmer module is comprised of two rollers; the pick roller and the drive roller (same part
number). Both rollers contain two, removable rubber tires (four total). One outer edge of each tire
contains at least 3 markers. These markers are used as a point of reference for correctly
installing the tires on the roller and also the rollers into the skimmer housing. If the tires are
installed incorrectly or the rollers installed in the skimmer housing incorrectly, the skimmer module
will not function properly.
If replacing tires, all four tires should be replaced at the same time. When replacing tires, also
replace the separator roller (see
60
"2.2.4.2 Configure Maintenance Reminders" on page
"Replacing the Separator Roller" on page

5.3.1 Feed Rollers

5.3.1.1 Skimmer Rollers

67).
S008769 Rev A
41).