Preemptive Multifeed Ignore; Batch Control; Ready Led - Kodak Ngenuity 9090DB Operator's Manual

Retain the Multifeed Image
- Press the MF IGNORE pushbutton on the scanner's control panel. After a couple of sec-
onds, the scanner will automatically eject the multifeed document and continue scanning
documents, retaining the multifeed image
The MF (MULTIFEED) IGNORE pushbutton toggles the multifeed ignore feature on/off. When
on, the scanner will ignore the multifeed sensor during the next page fed (one page only), and the
MULTIFEED LED will blink to indicate the activated ignore state.
It works in a preemptive manner in that during batch scanning, the Operator can avoid an
impending multifeed alarm without forcing a batch stop by pressing the MF IGNORE pushbutton
during a batch scan. Doing so turns off the MF alarm detection for a single page starting with the
next leading edge seen by the page entry sensor. To turn off MF detection for a series of
documents, press and hold the MF IGNORE pushbutton.
The final or bottom area of the control panel is labeled Batch
Control. The Batch Control section contains an LED indicator and
two pushbuttons that deal specifically with scanning start and
stop.
The READY LED indicator is green in color. It is lit when the Ngenuity scanner is
ready to scan (feeder ready, no unresolved errors, and the scanner is not otherwise
busy, i.e. internal operations due to activity of Ngenuity Operator Utility).
• ADF Feed Mode - the READY LED is lit steady when the documents to be scanned are in
position and ready to feed (assuming no error conditions are active)
• Manual Feed Mode - the READY LED is lit steady when scanning can begin and during
scanning
S008769 Rev A
P M
REEMPTIVE ULTIFEED

2.1.1 Batch Control

2.1.5.1 Ready LED

I
GNORE
27