Configure Maintenance Reminders - Kodak Ngenuity 9090DB Operator's Manual

The Configure Maintenance Reminders section of the
Maintenance screen allows the Operator to set and/or
adjust the interval values for triggering the reminders visible
in the Maintenance monitor of the Home screen
("2.2.2.3 Maintenance Monitor" on page
Intervals can be set for cleaning the Feed Rollers (skimmer
rollers - pick and drive, and separator roller), the Transport Rollers, the Optics, and to replace the
Feed Rollers (skimmer rollers and separator roller). The Operator can also individually enable/
disable the maintenance reminder feature for each of these components.
N
OTE
Although the ability exists to disable a maintenance reminder, BBH strongly recommends that
all maintenance reminders remain enabled on your Ngenuity scanner.
Assuming the reminder is enabled, when the specified interval has been reached, this feature will
light the scanner's Maintenance LED
Maintenance Monitor section of the NOU's Home screen (see
page 35).
To enable a specific maintenance reminder, click the check box next to the corresponding
component.
To set or change a specific component's interval, use the up/down arrow keys found in the
Interval column located to the right of the component label (e.g. the image above shows an
Interval of 600,000 to trigger the "Replace Feed Rollers" maintenance reminder.
Intervals refer to the number of pages fed. The available interval settings and their defaults are:
Reminder
Clean Feed Rollers (Skimmer Rollers & Separator Roller)
Clean Transport Rollers
Clean Optics (camera glass cover, glass flats, sensors)
Replace Feed Rollers (Skimmer & Separator Rollers)
If changes are made to any of the maintenance reminder settings, the Operator must either save
the changes (click the Save button) or restore the previously saved settings (click the Restore
button).
If changes are made and the Operator attempts to navigate out of the Maintenance screen, a
prompt dialog is displayed asking to either Save or Restore the settings.
S008769 Rev A

2.2.4.2 Configure Maintenance Reminders

35).
and a maintenance reminder will display in the
"2.2.2.3 Maintenance Monitor" on
Range Default
1K - 50K 10K
5K - 100K 50K
5K - 150K 50K
100K - 900K 600K
41