Cleaning Glass Flats; Flat - Kodak Ngenuity 9090DB Operator's Manual

The cameras' glass covers are part of the Optics group (see
W
ARNING
Never attempt to remove the glass flat from its frame. Doing so can cause the glass flat to
crack or break and could cause injury to the person holding it.
W
ARNING
Before performing any maintenance procedures, power OFF the scanner.
W
ARNING
Before performing any maintenance procedures on the scanner, remove all jewelry or any
items from hands or wrists that could become caught on internal scanner components.
Over time the glass flats will become dirty with smudges and/or paper dust which can case
streaks in images, reduced OCR/ICR/Barcode recognition rates, blurred images, etc.
To prevent these problems, BBH recommends cleaning the glass flats every 50,000 pages fed or
as needed. Different document types, the condition of the documents being scanned, and the
volume of scanning may require more frequent cleanings.
For best results, remove the glass flats and clean both sides of each.
Item(s) Needed
• Roller and Glass Cleaner
• Lint Free Cloth
C
AUTION
Never spray the Roller and Glass Cleaner into the scanner.
To clean the bottom (back page) glass flat, perform the following:
1. Power OFF the scanner (see 1.4.2 Scanner Back,
2. Open the scanner's transport cover (see 1.4.1 Scanner Front,
and "Transport Cover Release Levers" on page 7)
3. Remove the bottom (back page) glass flat
S008769 Rev A
"5.3.2 Optics" on page 68
C
LEANING
"Power Switch" on page
"Transport Cover" on page 7
above).
G F
LASS LATS
11)
69