Installation - Kodak Ngenuity 9090DB Operator's Manual

The following are instructions for installation of an Ngenuity scanner using a SCSI connection
type. These instructions must be followed in the order they appear:
To install and connect using a SCSI device, perform the following:
1. Follow the instructions found in the Ngenuity Quick Install Guide (S008842), taking care to fol-
low the published safety and environmental guidelines (see
and "1.3 Operating Environment" on page 3
Keep the original packing material (see
W
ARNING
The scanner weighs approximately 112 pounds (51 kg). Be sure to incorporate the appropriate
manpower (taking into consideration your lifting capabilities) before moving or lifting the
scanner.
2. Do NOT connect the scanner to the host PC. Power on the host PC and load the Ngenuity
VRS Professional software provided on the Ngenuity Installation Resource CD-ROM (do NOT
reboot the host PC after the installation)
3. Load the Ngenuity Operator Utility (NOU) on the host PC (do NOT reboot the host PC after
the installation, nor attempt to launch the NOU)
4. Power down the host PC and remove the power cord from the back of it
5. Install the SCSI card (Adaptec 29160) in the host PC
6. Connect the host PC to the scanner
7. Connect power to the scanner and reconnect power to the host PC
8. Power ON the scanner and wait for the initialization sequence to complete
9. Power on the host PC
10. Run through the New Hardware Found wizard
11. Launch the NOU by double clicking on the application's icon
Desktop
The NOU's Home Screen (default) will update once all
the scanner self tests have passed and communica-
tion with the scanner has been established. The
installation is complete!
If the NOU failed to connect with the scanner, refer to
"4.2.2 Troubleshooting" on page 55
54
in this manual)
"1.5 Unpacking/Repacking" on page
for information.

4.2.1 Installation

"1.2 Safety Guidelines" on page 1
12)
found on the host PC's
S008769 Rev A