Settings Screen; Sleep Timeout; Multifeed - Kodak Ngenuity 9090DB Operator's Manual

2.2.3 Settings Screen

Clicking the Settings button found in the
NOU displays the Settings screen.
From this screen, the Operator can
configure basic scanner settings such as
a scanner's sleep timeout delay, adjust
the document detection range for
multifeeds, specify the functions of the F1
and F2 buttons found in the Custom
Functions section of the scanner's control
panel, and specify and adjust the audio
features of the scanner.
The ability to configure advanced settings
(see "2.2.3.5 Advanced Settings Button"
on page 39), restore settings to their
previously saved state (Restore button),
and save new changes (Save button) is
also available from the Settings screen.

2.2.3.1 Sleep Timeout

The Sleep Timeout feature allows the Operator to set
a specific delay time in hours and minutes that the
scanner will sit idle with full power before lapsing into
a low-power Sleep Mode.
The default Sleep Timeout is 15 minutes and the
maximum time is four hours.

2.2.3.2 Multifeed

The Multifeed control allows the
Operator to adjust the scanner's
multifeed sensitivity when scanning
normal or very thin documents. The
two settings available for the
Document Detection Range are Normal and Very Thin.
Normal: This setting encompasses documents that range from thick card stock to thin carbon
copies and should be used for the majority of documents scanned.
S008769 Rev A 37