Kodak Ngenuity 9090DB Operator's Manual page 34

VRS ISIS-based Applications
- Kofax VRS Scanner
VRS TWAIN-based Applications
- Kofax Software VRS - TWAIN
6. Open the scanning application's Scanner Properties window
7. Using the drop down arrow for the Source control, select Manual
8. Save the change (in the image above - VCDemo Scanner Properties window - clicking the OK
button saves the changes)
N
OTE
The MANUAL FEED LED on the scanner's control panel does not automatically light. It will
light to signal that the scanner is in Manual mode once a scan command (single or batch) is
issued from the scanning software.
If the Operator changes the feed mode from Manual to ADF, the MANUAL FEED LED won't turn
off until a scan command (single or batch) using ADF mode is issued from the scanning
application.
9. The feeder table will not rise to the manual feed position until a scan command is issued.
Issue a single scan command or a batch scan command, and when the feeder table is in the
full up position, begin feeding documents, one at a time, into the scanner's transport.
Take care to feed each document far enough into the scanner so that the scanner is able to
grasp the document and feed it into and through the transport
N
OTE
To lower the feeder table for ADF mode scanning, the Operator must lift the skimmer module
to the full up position, make sure the paper tray is empty, and change the feeding mode from
Manual to ADF in the scanning application and issue a scan command (single or batch).
When a single scan command is issued, the scanner's transport begins to run. The Operator
is able to feed documents through the scanner (one at a time); however, because a single scan
22 S008769 Rev A