Clear/Restart Pushbutton; Pause/Stop Pushbutton - Kodak Ngenuity 9090DB Operator's Manual

The CLEAR/RESTART pushbutton is used for the following:
• To clear an error (one of the error indicators on the control panel is lit) and
resume scanning. This is only successful if whatever caused the error to
occur in the first place is resolved (i.e. paper removed from the transport which
caused a paper jam error and the PAPER JAM LED to light).
• To clear a multifeed error (when using VRS), which tells VRS to discard the multifeed image
and rescan the document
• To resume scanning after a batch pause
The PAUSE/STOP pushbutton is primarily used to stop the scanner's transport.
• If there is no scan command queued, no documents in the transport, and no feed-
ing in progress, pressing this pushbutton simply stops the transport prior to the
automatic transport timeout. This does not cause any errors
N
OTE
The automatic transport timeout is 20 seconds. The 20 seconds is not Operator adjustable.
• If the scanner is feeding documents, pressing this pushbutton once will initiate a controlled
transport motor stop (i.e. stop feeder and continue processing documents until the transport is
empty), and a host "scanner paused" error will occur
• If the PAUSE/STOP pushbutton is pressed twice or pushed and held for more than one sec-
ond, a hard stop will occur (scanning stops with documents remaining in the transport) along
with a host "scanner stopped" error (this host error will not happen if the scanner is running in
Test mode). Press the Clear/Restart pushbutton to resume scanning (there is a slight delay
before scanning resumes).
N
OTE
If the Clear/Restart pushbutton is pressed before all documents are cleared from the transport
and one of those documents is covering the exit sensor (refer to images found in
Transport Sensors" on page 76
sound and the PAPER JAM LED will light. Clear the transport of all documents by pressing
and holding the Custom Function pushbutton that is programmed to 'Page Eject'
"2.2.3.3 Custom Functions" on page
scanning (there is a slight delay before scanning resumes).
The PAUSE/STOP pushbutton is also used to immediately put the scanner in SLEEP mode by
pressing and holding the pushbutton for 5 seconds or longer. This can only be accomplished
when the scanner is fully idle (no scan commands queued) and the transport is not running).
28

2.1.5.2 Clear/Restart Pushbutton

2.1.5.3 Pause/Stop Pushbutton

for exit sensor location), an audible alarm on the scanner will
38) and then press the Clear/Restart pushbutton to resume
"Cleaning
(see
S008769 Rev A