Replacing The Separator Roller - Kodak Ngenuity 9090DB Operator's Manual

8. Once the separator roller and the skimmer rollers have been cleaned, reset the maintenance
reminder for cleaning the Feed Rollers located in the Maintenance Monitor section of the
NOU's Home Screen
- With the NOU active and communicating with
the scanner (see
Utility" on page
hyperlink associated with "Clean Feed
Rollers" in the Maintenance monitor of the
Home screen
- A confirmation dialog window will display.
Confirm the Feed Rollers have been cleaned
by clicking the YES button. This will reset the
reminder to begin monitoring for the next
required maintenance session
With proper cleaning, BBH estimates the life of the separator roller to equate to approximately
600,000 pages fed. Different document types, the condition of the documents being scanned,
and the volume of scanning may alter that number slightly.
For optimal performance, if having to replace the separator roller, replace the tires of the skimmer
rollers (pick and drive - 4 tires total) at the same time (see 5.3.1 Feed Rollers,
on page 63).
To replace the separator roller, perform the following:
1. Power OFF the scanner (see 1.4.2 Scanner Back,
2. Open the scanner's transport cover (see 1.4.1 Scanner Front,
and "Transport Cover Release Levers" on page 7)
3. Remove the separator roller (see
4. Remove the roller itself from the rest of the assembly as shown in the Exploded View image
of the separator roller found under
5. Reassemble the components using a new roller, duplicating the assembly shown in the
Exploded View image of the separator roller found under
page 65
6. Reinstall the separator roller into the scanner (see
page 66)
7. Discard the old roller
S008769 Rev A
"2.2 Ngenuity Operator
29), click on the Replace
"Cleaning the Separator Roller" on page
"5.3.1.2 Separator Roller" on page 65
R S
EPLACING THE
"Power Switch" on page
"Transport Cover" on page 7
"5.3.1.2 Separator Roller" on
"Cleaning the Separator Roller" on
R
EPARATOR OLLER
"Replacing Tires"
11)
66)
67