Custom Functions; Audio - Kodak Ngenuity 9090DB Operator's Manual

Very Thin: This setting is used to detect multifeeds when scanning ultra thin documents such as
rice paper. Attempting to scan any thick card stock with this setting will likely trigger the multifeed
alarm.
The Custom Functions section of the Settings screen in the NOU
corresponds with the Custom Functions area of the scanner's
panel (see "2.1.3 Custom Functions" on page
The Operator can set each function key (F1, F2) for
a specific task that is selectable from a drop down
list in the NOU.
The available tasks are:
• None (function key performs no function)
• Feed Test Batch (key activates Test Feed mode - go to
Feed mode)
• Page Eject (key invokes a brief transport turn-on to eject multifeed pages or clear the trans-
port after a stop)
• Clean Print Head (key invokes an imprinter print head cleaning cycle)
N
OTE
The Clean Print Head task functions only if an optional imprinter has been installed. For more
information on Ngenuity's optional imprinter, go to
The available tasks are the same for both the F1 and F2 keys and the default setting for each
function key is 'None'.
The Audio section of the Settings screen in the NOU
allows the Operator to set the scanner's audio
volume, as well as the tone sequence used when a
scanner error occurs.
The volume level can be set to Mute or a volume
range of Low, Med or High by moving the slider to
the desired choice.
One of three Error Sounds can be selected by clicking the radio button next to Sound1, Sound2,
or Sound3.
38

2.2.3.3 Custom Functions

control
24).
page 23 for more information on Test
"4.1 Imprinter" on page 53 in this manual.

2.2.3.4 Audio

S008769 Rev A