Juniper EX2300 Series Hardware Manual page 46

Table 11: Status LED on the RJ-45 Network Ports in EX2300 Switches Except the EX2300-24MP and
EX2300-48MP Models
Port Parameters
Administrative status (EN)
PoE status (PoE)
Starting in Junos OS Release 19.4R1, you can use the
switches except the EX2300-24MP and EX2300-48MP switch models to identify the switch or a port
on the switch. When you execute the command, the status LEDs on the RJ-45 network ports blink two
times per second irrespective of the mode the ports are operating in (see
Port Using the Chassis Beacon).
The uplink ports operate in full-duplex mode and PoE is not applicable on uplink ports. The Status LED
on uplink ports indicate the Speed (SPD) and Administrative status (EN).
the Status LED on the uplink ports in EX2300 switches except the EX2300-24MP and EX2300-48MP
switch models.
(Continued)
State and Description
Indicates the administrative status. The status indicators are:
•
Green—Port is administratively enabled.
•
Unlit—Port is administratively disabled.
Indicates the PoE status. The status indicators are:
•
On steadily—PoE is enabled on the port and a device is drawing power.
•
Blinking—PoE is enabled on the port, but no power is drawn from the
port.
•
Unlit—PoE is not enabled on the port.
NOTE: The PoE Status LED is available on the following EX2300 switch
models:
•
EX2300-C-12P
•
EX2300-24P
•
EX2300-48P
command on EX2300
request chassis beacon
How to Locate a Device or
Table 12 on page 38
37
describes