status mode LED (SPD, DX, EN, and PoE) is lit. The LED labeled PoE is not available on switch models
with RJ-45 network ports that do not provide PoE.
Figure 27: Port Mode LEDs on EX2300 Switches Except the EX2300-24MP and EX2300-48MP Models
1
Port mode LEDs
—
Table 11 on page 36
describes the Status LED on the RJ-45 network ports in EX2300 switches except
the EX2300-24MP and EX2300-48MP switch models.
Table 11: Status LED on the RJ-45 Network Ports in EX2300 Switches Except the EX2300-24MP and
EX2300-48MP Models
Port Parameters
Speed (SPD)
Duplex mode (DX)
NOTE: On EX2300-24T switches,
only the ports labeled 0/0 through
0/15 support half-duplex. On
EX2300-48T switches, only the
ports labeled 0/0 through 0/15 and
0/24 through 0/39 support half-
duplex.
State and Description
Indicates the speed. The speed indicators are:
•
Unlit—10 Mbps
•
Blinking—100 Mbps
•
On steadily—1000 Mbps
Indicates the duplex mode. The status indicators are:
•
Green—Port is set to full-duplex mode.
•
Unlit—Port is set to half-duplex mode.
36