Juniper EX2300 Series Hardware Manual page 181

• Baud rate—9600
• Flow control—None
• Data—8
• Parity—None
• Stop bits—1
• DCD state—Disregard
There are two ways to connect and configure an EX Series switch: one method is through the console by
using the CLI and the other is by using the J-Web interface.
NOTE: EX2200-24T-4G-DC switches do not support switch connection and configuration
through the J-Web interface.
This topic describes the CLI procedure.
NOTE: To run the ezsetup script, the switch must have the factory-default configuration as the
active configuration. If you have configured anything on the switch and want to run ezsetup,
revert to the factory-default configuration. See
for the EX Series Switch" on page
To connect and configure the switch from the console by using the CLI:
1. Connect the console port to a laptop or PC by using the RJ-45 to DB-9 serial port adapter. An
Ethernet cable that has an RJ-45 connector at either end and an RJ-45 to DB-9 serial port adapter
are supplied with the switch. If your laptop doesn't have a serial port, use a serial to USB adapter.
For the location of the console port on different EX Series switches:
• See EX2200 Switches Hardware
• See "EX2300 Switches Hardware Overview" on page
• See Rear Panel of an EX3200
• See Rear Panel of an EX3300
Rear Panel of an EX3400 Switch
• See
Rear Panel of an EX4200 Switch
• See
"Reverting to the Default Factory Configuration
179.
Overview.
2.
Switch.
Switch.
.
.
172