Juniper EX2300 Series Hardware Manual page 135

NOTE: Tighten the screws only part way in, leaving about 1/4 in. (6 mm) distance between
the head of the screw and the wall.
a. Drill a hole A and install a mounting screw.
b. Drill a hole B at a distance of 5.98 in. (15.2 cm) on a level line to the right from screw A and install
a mounting screw.
c. Drill a hole C at a distance of 18.67 in. (47.43 cm) on a plumb line down from screw A and install a
mounting screw.
d. Drill a hole D at a distance of 18.67 in. (47.43 cm) on a plumb line down from screw B and install a
mounting screw.
Figure 67: Measurements for Installing Mounting Screws to Mount an EX2300 Switch Except the
EX2300-24MP and EX2300-48MP Models and the EX2300-C Switch on a Wall
4. Place the switch against the wall such that the front panel of the switch faces to the right side and
the holes in the mounting brackets heads align with the mounting screw heads.
126