Juniper EX2300 Series Hardware Manual page 243

Table 57: Alarm Conditions on EX2300 Switches
Chassis Alarm Condition
Component
Management Management Ethernet
Ethernet link is down.
interface
Routing Engine /var partition usage is
high.
/var partition is full.
Rescue configuration
is not set.
Feature usage requires
a license or the license
for the feature usage
has expired.
SEE ALSO
Chassis Status LEDs in EX2300 Switches | 26
(Continued)
Alarm Remedy
Severity
Major (red)
•
Check whether a cable is connected to the
management Ethernet interface, or whether the
cable is defective. Replace the cable if required.
•
If you are unable to resolve the problem, open a
support case using the Case Manager link at
https:/ /www.juniper.net/support/
1-888-314-5822 (toll-free within the United States
and Canada) or 1-408-745-9500 (from outside the
United States).
Minor Clean up the system file storage space on the switch.
(yellow) For more information, see
Space.
Major (red) Clean up the system file storage space on the switch.
For more information, see
Space.
Minor request system configuration rescue save
Use the
(yellow)
command to set the rescue configuration.
Minor Install the required license for the feature specified in
(yellow) the alarm. For more information, see
Software Licenses for EX Series
or call
Freeing Up System Storage
Freeing Up System Storage
Understanding
Switches.
234