Juniper EX2300 Series Hardware Manual page 185

1. Transition the switch into initial setup mode:
• EX2200 and EX2200-C switch—Press the mode button located on the lower right corner of the
front panel for 10 seconds.
• EX3200, EX3300, EX4200, EX4300 switches except EX4300-48MP and EX4300-48MP-S
switches, EX4500, EX4550, EX6200, or EX8200 switch—Use the Menu and Enter buttons
located to the right of the LCD panel (see
Figure 88: LCD Panel in an EX3200, EX4200, EX4500, EX4550, or EX8200 Switch
Figure 89: LCD Panel in an EX4300 Switches Except EX4300-48MP and EX4300-48MP-S
Switches
LCD panel
1
—
LCD panel Enter button
2
—
a. Press the Menu button until you see MAINTENANCE MENU. Then press the Enter button.
b. Press Menu until you see ENTER EZSetup. Then press Enter.
If EZSetup does not appear as an option in the menu, select Factory Default to return the
switch to the factory default configuration. EZSetup is displayed in the menu of standalone
switches only when a switch is set to the factory default configuration.
c. Press Enter to confirm setup and continue with EZSetup.
2. Connect the Ethernet cable from the Ethernet port on the PC to the switch.
Figure 88 on page 176 or
LCD panel Menu button
3
—
Chassis status LEDs
4
—
Figure 89 on page 176):
176