1
LEDs on the uplink ports
—
Figure 26: LEDs on the Uplink Ports in an EX2300 Switches Except the EX2300-C, EX2300-24MP, and
EX2300-48MP Switche Models
1
LEDs on the uplink ports
—
Table 10 on page 35
describes the Link/Activity LED on EX2300 switches except the EX2300-24MP
and EX2300-48MP models.
Table 10: Link/Activity LED on the RJ-45 Network Ports and Uplink Ports in EX2300 Switches Except
the EX2300-24MP and EX2300-48MP Models
LED
Color
Link/Activity
Green
Figure 27 on page 36
shows the LEDs on EX2300 switches except the EX2300-24MP and
EX2300-48MP models that indicate the status of one of the four port parameters—speed, duplex mode,
administrative status, and Power over Ethernet (PoE) status. Use the Factory Reset/Mode button on the
far right side of the front panel to toggle the Status LED to show the different port parameters for RJ-45
network ports. You can tell which port parameter is indicated by the Status LED by looking at which port
State and Description
•
Blinking—The port and the link are active, and there is link
activity; or the switch is transitioning to the EZSetup mode.
•
On steadily—The port and the link are active, but there is no link
activity; or the switch is reverting to the factory default
configuration.
•
Off—The port is not active.
35