Juniper EX2300 Series Hardware Manual page 192

NOTE: To revert a member switch of a Virtual Chassis to the factory-default configuration,
disconnect the cables connected to the VCPs to avoid affecting Virtual Chassis configuration
parameters (member ID, primary-role priority, and setting of VCP uplinks) on other members (see
Disconnect a Fiber-Optic Cable
To revert to the factory-default configuration by using the Factory Reset/Mode button:
1. Press the Factory Reset/Mode button for 10 seconds. The switch transitions into factory-default
configuration, the console displays committing factory default configuration, and the Link/Activity
LED on the RJ-45 network ports and the uplink ports is lit steadily in green color.
2. Press the Factory Reset/Mode button for 10 more seconds. The switch transitions into initial setup
mode, the console displays committing ezsetup config, and the Link/Activity LED on the RJ-45
network ports and the uplink ports blink in green color.
The Factory Reset/Mode button is enabled by default. You can disable the button using the CLI.
To disable the Factory Reset/Mode button, run the commands:
1. [edit]
user@switch# set chassis config-button no-clear
2. [edit]
user@switch# commit
To enable the Factory Reset/Mode button, run the commands:
1. [edit]
user@switch# delete chassis config-button no-clear
2. [edit]
user@switch# commit
RELATED DOCUMENTATION
Connecting and Configuring an EX Series Switch (CLI Procedure) | 171
Connecting and Configuring an EX Series Switch (J-Web Procedure) | 175
Understanding Configuration Files
).
183