Juniper EX2300 Series Hardware Manual page 126

NOTE: One person must be available to lift the switch while another secures it to the rack.
CAUTION: If you are mounting multiple units on a rack, mount the heaviest unit at the
bottom of the rack and mount the other units from the bottom of the rack to the top in
decreasing order of the weight of the units.
To mount the switch on four posts of a rack:
1. Remove the switch from the shipping carton (see
2. Attach the front-mounting brackets (either the flush or the 2-in.-recess brackets) to the side
mounting-rails by using 6 Phillips 4-40 flat-head mounting screws. See
Figure 58: Attaching the Front-Mounting Bracket to the Side Mounting-Rail
Side mounting-rail
1
—
3. Place the switch on a flat, stable surface.
4. Align the side mounting-rails along the side panels of the switch chassis. Align the two holes in the
rear of the side mounting-rails with the two holes on the rear of the side panel.
"Unpacking an EX2300 Switch" on page
Figure 58 on page
Front-mounting bracket
2
—
117
101).
117.