Juniper EX2300 Series Hardware Manual page 17

3 Port status mode LEDs. The LED labeled PoE
—
is present only on models with PoE
capability.
Figure 4: Front Panel of an EX2300 Switch with 48 Gigabit Ethernet Ports with PoE Capability Except
the EX2300-48MP Model
1 RJ-45 network ports
—
2 Chassis status LEDs
—
Port status mode LEDs. The LED labeled PoE
3
—
is present only on models with PoE
capability.
The front panel of EX2300-24MP switch models consists of the following components:
• QR code
• System LEDs
• One USB port
• One management port
• Eight 100/1000/2500 BASE-T Gigabit Ethernet ports with PoE/PoE+ capability
• 16 10/100/1000 BASE-T Gigabit Ethernet ports with PoE/PoE+ capability
• Four built-in 10-Gigabit Ethernet uplink ports. You can use these ports to forward network traffic or
configure them into VCPs to interconnect EX2300 switches into a Virtual Chassis.
• One RJ-45 console port
The front panel of EX2300-48MP switch models consists of the following components:
• QR code
• System LEDs
6 10-Gigabit Ethernet uplink ports
—
4 Factory Reset/Mode button
—
5 Mini-USB console port
—
10-Gigabit Ethernet uplink ports
6
—
8