Juniper EX2300 Series Hardware Manual page 124

NOTE: The length of the mounting brackets depends on the switch model.
4. Align the bottom holes in the mounting brackets with the holes on the side panels of the switch
chassis.
5. Insert the mounting screws into the aligned holes. Tighten the screws.
6. Ensure that the other holes in the mounting brackets are aligned with the holes in the side panels.
Insert a screw in each hole and tighten the screws.
7. Have one person grasp both sides of the switch, lift the switch, and position it in the rack, aligning
the mounting bracket holes with the threaded holes in the rack rail. Align the bottom hole in each
mounting bracket with a hole in each rack rail, making sure the chassis is level. See
115.
Figure 57: Mounting the Switch on Two Posts of a Rack
8. Have a second person secure the switch to the rack by using the appropriate screws. Tighten the
screws.
9. Ensure that the switch chassis is level by verifying that all screws on one side of the rack are aligned
with the screws on the other side.
Figure 57 on page
115