Juniper EX2300 Series Hardware Manual page 127

5. Insert the Phillips 4x6-mm flat-head mounting screws into the two aligned holes and tighten the
screws. Ensure that the two holes in the rear of the side mounting-rails are aligned with the
remaining two holes in the side panel. See
Figure 59: Attaching the Side Mounting-Rail to the Switch Chassis
6. Insert the Phillips 4x6-mm flat-head mounting screws into the remaining two holes in the side
mounting-rails and tighten the screws.
7. Have one person grasp both sides of the switch, lift the switch, and position it in the rack, aligning
the side mounting-rail holes with the threaded holes in the front post of the rack. Align the bottom
hole in both the front-mounting brackets with a hole in each rack rail, making sure that the chassis
is level. See Figure 60 on page
Figure 60: Mounting the Switch to the Front Posts of a Rack
8. Have a second person secure the front of the switch to the rack by using the appropriate screws for
your rack.
Figure 59 on page
118.
118.
118