Juniper EX2300 Series Hardware Manual page 254

user@switch> request system
storage cleanup dry-run
This command does not delete files in the
tmp only.
2. If any directory is taking up a lot of memory, delete unwanted files in that directory. Check the
memory utilization by using the command:
user@switch> show system storage
3. Delete non-recovery snapshots.
• If Junos OS 15.1X53D56 or later is installed in your switch:
a. Delete non-recovery snapshots by using the command:
user@switch> request system
software add software-image-name force
• If a version of Junos OS released earlier than Junos OS 15.1X53D56 is installed in your switch:
a. Check for non-recovery snapshots by using the command:
user@switch> show system snapshot
b.
NOTE: Snapshot names are not completed automatically in the CLI; you must enter the
snapshot name.
Delete non-recovery snapshots by using the command:
user@switch> request system
snapshot delete snapshot-name
root folder; it deletes files in the folders jail , log , and
245