Juniper EX2300 Series Hardware Manual page 120

NOTE: Figure 53 on page 111
switch is viewed from the top. The internal components and top cover are not shown.
Figure 53: Measurements for Installing Mounting Screws for Mounting EX2300-C Switches Under a
Desk or Other Level Surface by Using Screws
NOTE: Tighten the screws only part way in, leaving about 1/4 in. (6 mm) distance between
the head of the screw and the desk or the level surface.
a. Drill a hole A and install a mounting screw.
b. Drill a hole B at a distance of 8.56 in. (21.7 cm) on a level line from hole A and install a mounting
screw.
shows the bottom panel of an EX2300-C switch when the
111