Juniper EX2300 Series Hardware Manual page 187

Configure in-band management . In in-band management, you configure a network interface or
•
an uplink module (expansion module) interface as the management interface and connect it to
the management device.
In this scenario, you have the following two options:
• Use the automatically created VLAN
all data interfaces as members of the default VLAN. Specify the management IP address and
the default gateway.
• Create a new VLAN for management—Select this option to create a management VLAN.
Specify the VLAN name, VLAN ID, management IP address, and default gateway. Select the
ports that must be part of this VLAN.
Configure out-of-band management —Configure the management port. In out-of-band
•
management, you use a dedicated management channel (MGMT port) to connect to the
management device. Specify the IP address and gateway of the management interface. Use this
IP address to connect to the switch.
8. Click Next.
9. On the Manage Access page, you can select options to enable Telnet, SSH, and SNMP services. For
SNMP, you can configure the read community, location, and contact.
10. Click Next. The Summary screen displays the configured settings.
11. Click Finish. The configuration is committed as the active switch configuration.
NOTE: After the configuration is committed, the connectivity between the PC and the
switch might be lost. To renew the connection, release and renew the IP address by
executing the appropriate commands on the management PC or by removing and
reinserting the Ethernet cable.
12. (For EX4500 switches only) In the CLI, enter the request chassis pic-mode intraconnect operational
mode command to set the PIC mode to intraconnect.
You can now log in by using the CLI or the J-Web interface to continue configuring the switch.
If you use the J-Web interface to continue configuring the switch, the Web session is redirected to the
new management IP address. If the connection cannot be made, the J-Web interface displays
instructions for starting a J-Web session.
default for management—Select this option to configure
178