Juniper EX2300 Series Hardware Manual page 208

Table 46: Chassis Viewer for EX3200, EX3300, and EX4200 Switches
Field
Front View
Interface status
LCD panel
Rear View of the EX3200 Switch
Management (me0)
port
Console port
Description
In the image, the following colors denote the interface status:
•
Green—Interface is up and operational.
•
Yellow—Interface is up but is nonoperational.
•
Gray—Interface is down and nonoperational.
Mouse over the interface (port) to view more information.
For a Virtual Chassis configuration, select the switch to view the interface status.
If an SFP+ uplink module is installed in the switch, mouse over the port icon to display
whether the module is configured to operate in 1-gigabit mode or in 10-gigabit mode. If
the module is configured to operate in 1-gigabit mode, the tool tip information is
displayed for all 4 ports. If the module is configured to operate in 10-gigabit mode, the
tool tip information is displayed only for 2 ports.
On an EX3300 switch with the 4x GE/XE SFP+ module, mouse over the port icon to
display whether the module is configured to operate in 1-gigabit mode or 10-gigabit
mode.
For SFP, SFP+, and XFP ports, the interfaces appear dimmed if no transceiver is
inserted. The chassis viewer displays
the port icon.
LCD panel configured for the LEDs on the ports. Mouse over the icon to view the
current character display.
The management port is used to connect the switch to a management device for out-
of-band management.
The console port is used to connect the switch to a management console or to a
console server. (You might do this for initial switch configuration.)
Transceiver not plugged-in
when you mouse over
199