Communication Cable Specifications - YASKAWA PROFINET JOHB-SMP3 Technical Manual

5 Installation Procedure
4.
Remove the screw (D) installed in the drive grounding terminal (A).
5.
Use the screw (C) installed in the FE ground terminal of the drive (A) to connect one end of the included
ground wire (H) to the ground terminal on the drive.
Route ground wire on the right side of the stud (K).
Tighten the screw to a correct tightening torque:
• 0.5 N∙m to 0.6 N∙m (4.4 lbf∙in to 5.3 lbf∙in)
6.
Install the option (B) into the CN5 connector (M) (HV600: CN5, FP605: CN5-A) on the drive and use one
of the included screws (C) to put it in place.
Tighten the screw to a correct tightening torque:
• 0.5 N∙m to 0.6 N∙m (4.4 lbf∙in to 5.3 lbf∙in)
Note:
Only two screws are necessary to install the option on HV600 and FP605 drives.
7.
Use one of the remaining included screws (C) to connect the ground wire (H) to the ground terminal and
installation hole on the option (B).
Refer to Figure 5.7
Tighten the screw to a correct tightening torque:
• 0.5 N∙m to 0.6 N∙m (4.4 lbf∙in to 5.3 lbf∙in)
8.
Firmly connect the Ethernet communication cables to CN1B (Port 2) (I), and/or CN1A (Port 1) (J).
Isolate communication cables from main circuit wiring and other electrical and power lines. Make sure that
you firmly connect the cable end. Refer to
information.
9.
Reattach the drive front cover (E) and the keypad (F).
Refer to the drive manuals for more information.
NOTICE
erroneous operation.
10.
Set drive parameters in
◆

Communication Cable Specifications

Yaskawa recommends using shielded Cat5e cable or better. The Yaskawa warranty does not cover other cable
types.
20
for instruction about crimp terminal orientation and wire routing.
Do not pinch cables between the front covers and the drive. Failure to comply could cause
Related Drive Parameters on page 22
Communication Cable Specifications on page 20
for correct option performance.
YASKAWA SIEP C730600 0KA PROFINET Technical Manual
for more