Description and Operation
Operation
Charging the Batteries
3. Open the SIM1 or SIM2 card cover.
Note:
If you intend to insert only one SIM card, always insert it to the SIM1 slot.
4. Gently insert the SIM card contacts facing up into SIM card holder until it clicks.
5. Close the cover.
6. Place the battery pack back into the receiver, make sure it is firmly established.
3.3. Charging the Batteries
C
: Risk of explosion if battery is replaced by an incorrect type. Dispose of used battery according to the
AUTION
instructions.
Before beginning to work, fully charge the batteries for maximum operating time. An approximately 6-
hour charge cycle will fully charge the batteries; the batteries will charge simultaneously. The batteries
can not be overcharged.
Note:
The batteries are shipped from the factory with 40% of power. Fully charge the batteries before surveying.
The Li-Ion batteries used in the battery packs should run at no less than 80% capacity after 500 charging
cycles. These batteries do not need to be drained before recharging.
D
: N
ANGER
EVER ATTEMPT TO OPEN THE CASING OF THE DETACHABLE BATTERIES
CAN BE DANGEROUS IF MISHANDLED
D
: D
ANGER
O NOT INCINERATE OR HEAT BATTERY PACK ABOVE
C
). E
ELSIUS
XCESSIVE HEAT CAN CAUSE SERIOUS DAMAGE AND POSSIBLE EXPLOSION
18
SIM2
Figure 10. SIM card slots
!
SIM1
! L
ITHIUM
212
F
DEGREES
AHRENHEIT
-I
ON BATTERIES
(100
DEGREES
.
www.javad.com
Need help?
Do you have a question about the TRIUMPH-VS and is the answer not in the manual?