Creating New Test Protocols - Interacoustics Affinity 2.0 Additional Information
Hide thumbs
Also See for Affinity 2.0:
- Instructions for use manual (75 pages) ,
- Additional information (384 pages)
Table of Contents
Advertisement
2.8.2
Creating new test protocols
The f ollowing sections describe how to setup your own protocol in the REM440 setup. All setup options f or
all tests will be described even though you most likely will only need a f ew. This section is theref ore to be
seen as a work of ref erence where single f unctions can be looked up rather than a step-by-step guide where
all steps need to be explored.
1) Enter the REM440 setup by pressing Menu/Setup/REM440 setup
2) Press New
3) A pop-up will give you the choice f or the new protocol to a copy settings from one of the current
protocols in your system. If you do not wish to do this, then you can click on the box 'Create a new
empty protocol'.
You will also be asked to title the new protocol in the section 'New protocol name:'.
D-0004576-Q – 2022/05
Affinity/Equinox2.0 – Additional Information
Page 214
Advertisement
Table of Contents
