Table of Contents
Advertisement
2.3 Moving the chair to test room
It is recommended that two persons are present when moving the Orion Chair.
The Orion chair is strapped to a 2-wheel steel hand truck inside the crate. A wooden ramp which is part of
the equipment on the pallet, is fastened with screws to the chair pallet, so the installer can roll the Orion chair
down from the pallet.
Remove the wooden brace over the footrest of the chair.
Attach the ramp to the front of the pallet using the two screws which fixed the ramp to side four, see Figure 5.
Figure 5: Pallet with fixed ramp
Remove the fixture securing the chair base to the palette.
Use the hand truck to tilt back the Orion Chair and roll it down on the ramp off the palette into the test room
where it is to be used. It is recommended that a second person supports and helps to tilt the Orion Chair by
the footrest during this step, see Figure 6.
D-0120794-D – 2023/06
Orion Reclining Chair Installation Instructions
Page 11
Advertisement
Table of Contents
