Comparing Curves - Interacoustics Affinity 2.0 Additional Information

3.6.9

Comparing curves

The HIT440 also allows f or comparing either two historical curves (e.g., two OSPL90 curves) or comparing a
historical curve to a currently recorded curve. This is done f ollowing the procedure described below:
1) Find the f irst curve in the Session list. Historical HIT measures are listed by date and time of
saving.
2) Press Toggle between lock and unlock the selected session
Find the second curve in the Session list. This can be either a curve of the current session or a
3)
historical curve.
The two curves are now shown in an overlap view as illustrated below:
Note: To avoid comparing apples to oranges, only curves of the same type can be compared – hence it is
not possible to compare results f rom an ANSI based test protocol with curves acquired with an IEC or
Custom based test protocol. Ideally the same test protocol should be used f or this type of comparison.
D-0004576-Q – 2022/05
Affinity/Equinox2.0 – Additional Information
Page 291