3. Remove the fuse.
4. Insert the proper fuse into the fuse holder.
5. Re-insert the fuse holder into the power socket.
WARNING
To avoid electric shock, please make sure that the instrument is powered off and
disconnected from the power before replacing the fuse. Also, please make sure the fuse is
consistent with the required fuse rating.
4.3.5
Setting the System Language
This oscilloscope supports multiple languages. You can click or tap
Setup > Language to select the system language.
4.3.6
Connecting Probes
RIGOL provides passive and active probes for HDO4000 series. For specific probe
models, please refer to
of the probes, please refer to the corresponding Probe User Guide.
Connect the Passive Probe
1. Connect the BNC terminal of the probe to an analog channel input terminal of the
oscilloscope on the front panel as shown in the figure below.
2. Connect the ground alligator clip or spring of the probe to the circuit ground
terminal, and then connect the probe tip to the circuit point to be tested.
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
Figure 4.5 Replacing the Fuse
HDO4000 series Data Sheet . For detailed technical information
Quick Start
> Utility >
HDO4000 User Guide
15