Setting The System Language; Connecting Probes; Function Inspection; Figure 4.6 Connecting The Passive Probe - Rigol DHO1000 Series User Manual

4.3.5
4.3.6
4.3.7
1.888.610.7664
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.

Setting the System Language

This oscilloscope supports multiple languages. You can click or tap
Setup > Language to select the system language.

Connecting Probes

RIGOL provides passive probes for DHO1000 series. For specific probe models, please
DHO1000 series Data Sheet . For detailed technical information of the probes,
refer to
please refer to the corresponding Probe User Guide.
Connect the Passive Probe
1. Connect the BNC terminal of the probe to an analog channel input terminal of the
oscilloscope on the front panel as shown in the figure below.
2. Connect the ground alligator clip or spring of the probe to the circuit ground
terminal, and then connect the probe tip to the circuit point to be tested.

Figure 4.6 Connecting the Passive Probe

After you connect the passive probe, check the probe function and probe
compensation adjustment before making measurements. For details, please refer to

Function Inspection

and
Function Inspection
1. Press the front-panel
is displayed. Click or tap OK to restore the instrument to its factory default
settings.
www.calcert.com
15
10 20
5 25
0 30
Probe Compensation
.
and a prompt message "Restore default settings?"
Quick Start
> Utility >
sales@calcert.com
DHO1000 User Guide