Table of Contents
Advertisement
5
Vertical System
This series oscilloscope provides 4 analog input channels (CH1-CH4), and each
channel is equipped with an independent vertical control system. The setting
methods for their vertical systems are the same. This chapter takes CH1 as an
example to introduce the setting method for the vertical system.
When a channel is selected, click or tap the channel status label at the bottom of the
screen. Then the menu as shown in the figure below is displayed.
5.1
To Enable or Disable the Analog Channel
Enable the analog channel
When a signal is connected to CH1, you can enable the channel by the following
methods.
•
Click or tap the channel status label at the bottom of the screen to enable the
channel.
•
Press the front-panel key
key is illuminated.
Vertical System
•
In
switch to turn CH1 on or off.
When CH1 is activated, its status label at the bottom of the screen is as shown in the
figure below.
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
Figure 5.1 Vertical Menu
to enable the channel, and the backlight of this
menu, select the CH1 tab. Click or tap the Display on/off
Vertical System
HDO4000 User Guide
41
Advertisement
Table of Contents
