Table of Contents
Advertisement
Click or tap the input field of File Name to input the file name to be saved with
the pop-up virtual keypad.
•
Set the file path
Click or tap the input field of File Path, then the disk management interface is
displayed. Select the target file path and then click or tap OK. For detailed
operations, refer to descriptions in
When a USB device is not connected, the default file path is the "Local Disk";
when a USB device is detected, the path is automatically set to "D:".
•
Overlay
Click or tap the Overlay on/off switch to enable or disable the overwriting
function. When this function is enabled, the existing file in the specified file path
will be overwritten by the newly saved file that has the same filename as the
existing one.
Click or tap Save, the current waveform file is saved based on the settings and the
storage menu is disabled.
TIP
When the quick action function is set to "Save Setup" or "Save Group" with "Save Setup"
selected, you can press the front-panel
20.2.4
Binary Data Format (.bin)
Binary data format stores waveform data in binary format and provides data headers
that describe these data. As data are displayed in binary format, its file size is much
more smaller than that in ASCII format. If several channels are enabled, then all the
displayed channels will be saved (save the first channel then save the second, and
then it goes on like this until all the displayed channels are saved).
Table 20.1 BIN File Format
File
Header
12 Bytes
In BIN file format, it contains the following channel data:
•
CH1 Data
•
CH2 Data
•
CH3 Data
•
CH4 Data
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
Waveform
Waveform
Header
Data
Header
128 Bytes
12 Bytes
Disk Management
.
key to save the setup.
Channel
Waveform
Data
Header
n Bytes
128 Bytes
Store and Load
Waveform
Channel
Data
Data
Header
12 Bytes
n Bytes
HDO4000 User Guide
247
Advertisement
Table of Contents
