Table of Contents
Advertisement
Triggering the Oscilloscope
the upper limit and lower limit values change at the same time. The difference
between upper and lower limit remains unchanged. For details, refer to
The current trigger level is displayed in the trigger information label at the top of the
screen.
Trigger Condition
Click or tap the drop-down button of When to select the desired trigger condition.
•
Sync: triggers on the specified sync type. After this trigger condition is selected,
click or tap the drop-down button of Sync to select the desired sync type: Data
Sync, Cmd/Status Sync, or All Sync.
•
Data: triggers on the specified data word. After this trigger condition is selected,
click or tap the comparison conditions in Comp. The available choices include =,
≠, >, <, ><, and <>.
-
-
-
-
-
-
•
RTA: triggers on the specified remote terminal address. After this trigger
condition is selected, click or tap the input field of RTA, and then the "Format"
HDO4000 User Guide
126
=: triggers when the channel's data word equals the set data word. Click or
tap the input field of Min, and then the "Format" interface is displayed. You
can set the lower limit of the data word. For details, refer to descriptions in
I2C Trigger
.
≠: triggers when the channel's data word does not equal the set data word.
Click or tap the input field of Min, and then the "Format" interface is
displayed. You can set the lower limit of the data word. For details, refer to
I2C Trigger
descriptions in
>: triggers when the channel's data word is greater than the set data word.
Click or tap the input field of Min, and then the "Format" interface is
displayed. You can set the lower limit of the data word. For details, refer to
I2C Trigger
descriptions in
<: triggers when the channel's data word is smaller than the set data word.
Click or tap the input field of Max, and then the "Format" interface is
displayed. You can set the upper limit of the data word. For details, refer to
descriptions in
I2C Trigger
< >: triggers when the channel's data word is smaller than the upper limit
of the data word and greater than the lower limit of the data word. Click or
tap the input field of Max and Min, and then the "Format" interface is
displayed. You can set the upper limit and lower limit of the data word. For
details, refer to descriptions in
> <: triggers when the channel's data word is greater than the upper limit
of the data word and smaller than the lower limit of the data word. Click or
tap the input field of Max and Min, and then the "Format" interface is
displayed. You can set the upper limit and lower limit of the data word. For
details, refer to descriptions in
.
.
.
I2C Trigger
.
I2C Trigger
.
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
Trigger Level
.
Advertisement
Table of Contents
