Other Parameters; Select The Measurement Item - Rigol HDO4000 Series User Manual

Digital oscilloscope
Hide thumbs Also See for HDO4000 Series:
Table of Contents

Advertisement

Wherein,
value, and
10.1.5

Other Parameters

Positive Slew Rate: On the rising edge, first calculate the difference between the
high value and the low value, then use the difference to divide the
corresponding time value to obtain the positive slew rate.
Negative Slew Rate: On the falling edge, first calculate the difference between
the low value and the high value, then use the difference to divide the
corresponding time value to obtain the negative slew rate.
Area: indicates the area of the whole waveform within the screen. The unit is V*s.
The area of the waveform above the zero reference (namely the vertical offset) is
positive, and the area of the waveform below the zero reference is negative. The
area measured is the algebraic sum of the area of the whole waveform within the
screen.
Period Area: indicates the area of the first period of waveform on the screen.
The unit is V*s. The area of the waveform above the zero reference (namely the
vertical offset) is positive, and the area of the waveform below the zero reference
is negative. The area measured is the algebraic sum of the whole period area.
10.2

Select the Measurement Item

In the Measure menu, click or tap Horizontal, Vertical, or Other to go to the desired
menu. You can also slide to select the measurement item to enter the corresponding
interface, as shown in
the measurement items to enable the measurements. This series allows you to enable
measurements of up to 14 items at the same time.
TIP
You can also refer to
Vertical: Vmax, Vmin, Vpp, Vtop, Vbase, Vamp, Vupper, Vmid, Vlower, Vavg,
VRMS, Per. VRMS, Overshoot, Preshoot, Area, Per.Area, and AC.RMS.
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
S
td
.
Dev
x
is the amplitude of the
i
n is the number of points being measured.
Figure 10.4
Figure 10.5
,
Multi-pane Windowing
n
2
(
x
Average
)
i
i
1
=
=
n
ith point, Average is the waveform average
Figure 10.6
, and
to enable all measurements.
Measurements
. Click or tap any of
HDO4000 User Guide
155

Advertisement

Table of Contents
loading

This manual is also suitable for:

Hdo4204Hdo4404Hdo4804

Table of Contents