Set the alignment mode
Click or tap the drop-down button of Alignment to select the alignment way for data
signal. The available choices include "I2S", "LJ", and "RJ".
Set the audio polarity
Click or tap the drop-down button of WS Low to select "Left" or "Right".
Set the data polarity
In Data Polarity menu, click or tap to select "Positive" or "Negative".
15.7.3
Display-related Settings
In Decode menu, set the following display-related parameters.
Set the Display Format
Click or tap the drop-down button of Format to select the display format of the bus
data. The available options include "Hex", "Dec", "Bin", and "ASCII".
Set the Label Display
Click or tap the Label on/off switch to enable or disable the label display of the
decoding bus. When enabled, the bus label will be displayed at the upper-left side of
the bus (when the bus display is enabled). The label shows the current bus type.
15.7.4
Event Table
Open or Close the Event Table
Click or tap the Event Table on/off switch to enable or disable the display of the
event table. When enabled, the event table is displayed as shown in the figure below.
You can also click or tap the icon
the event table.
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
at the upper-right corner of the table to close
Protocol Decoding
HDO4000 User Guide
217